Checking The Operation Of Input Units; Preparations For Checking - Yamaha CS1D Owner's Manual

Checking the operation of input units

This section explains how to check the operation of an input unit connected to the DSP1D-EX {DSP1D} engine.
The general procedure is as follows.
Connect an input source to the input unit
m m m m
Connect a monitor system (or headphones) to the MONITOR OUT A jacks of the console (or to the MONITOR A
headphone jack)
m m m m
Turn on the power in the order of input unit
m m m m
Patch the input unit to an input channel
m m m m
Press the [CUE] switch of the input channel
m m m m
Check whether the signal is output from the MONITOR OUT A jacks (or the MONITOR A headphone jack)

Preparations for checking

Before you begin checking the operation of the input unit, make sure that you have performed the following actions.
Connect the various components that are part of
the PM1D system ( p.6–13)
Use the indicators/LEDs of the input/output units
and the engine to verify that the components are
correctly connected to each other ( p.14–21)
Set the operation mode and the word clock master
as appropriate for the configuration of the PM1D
system that you are using ( p.22–29).
30
DSP1D-EX {DSP1D} engine CS1D console monitor system