Sending A Signal From A Mix Channel To An Output Unit - Yamaha CS1D Owner's Manual

Control surface digital audio mixing system

Hide thumbs Also See for CS1D:

Table of Contents

CS1D Operating Manual (Basic Operation)

Sending a signal from a MIX channel to an output unit

Here's how the signal sent from an input channel to the MIX bus can be output from the output unit patched to the cor-

responding MIX channel.

1. Make sure that an appropriate signal is being sent

from the input channel to the MIX bus. Also make

sure that a valid output unit is patched to the corre-

sponding MIX channel.

2. In the MIX OUTPUT block, turn on the MIX [ON]

switch for the MIX channel of the output unit to

which the signal will be sent.

3. In the MIX OUTPUT block, raise the MIX [LEVEL]

The signal of the corresponding MIX channel will be

output from the output unit that is patched to that

4. In order to use the meter bridge to check the (post-

fader) level of the signal sent from the MIX bus to

the output unit, go to the METER section in the

MASTER block of the console, turn on the METER

SELECT [MIX 25-48] switch, and turn off the

METER [PRE] switch.

With these settings, the 48 meters in the left and right

sides of the meter bridge will show the post-fader

levels of the MIX channels.

MASTER block

METER SELECT

[MIX 25-48] switch

The detection point (metering point) shown in the

meters can be speciﬁed in greater detail. For details

refer to the section "Setting the metering point" in

"Chapter 16. Various settings."

Table of Contents