Yamaha CS1D Owner's Manual page 31

This is the SYSTEM CONNECTION screen, in
which you can check the connection status of the
various components, and select the operation mode.
2. Click the button located at the right of "OPERA-
TION MODE."
The OPERATION MODE window will appear, in
which you can select the operation mode.
3. Click the button marked "CONSOLE x 1 <->
ENGINE x1."
Clicking "CONSOLE x 1 <-> ENGINE x1" will select
"Standard mode," and you will then return to the
previous screen.
If both sets of connectors (1/2)
are connected, two lines will be
displayed in the screen. In this
case, the connector for the
transmitting device in the
graphic will show the number of
the currently-valid connector.
If the connection is broken, an
"x" symbol will be displayed
instead of the number.
This shows the connection sta-
tus between the console and
engine. The light blue line in the
screen shows the control signal
connection, and the red line
shows the digital audio signal
connection.
Basic settings (Standard mode)
Verify that the OPERATION MODE field indicates
"CONSOLE x1 <-> ENGINE x1."
When you perform this switch, the word clock will
be reset. At this time, noise may be produced from
the output jacks of the CS1D or AO8 (in particular
if an MY8-AT digital I/O card is installed in the
DIO8). In order to protect your speakers, you must
turn down the output of the power amp before
changing this setting.
Hint
In the SYSTEM CONNECTION screen you can also
check the cabling within the system and the status of
each device.
This indicates the type This indicates the type This indicates the type of
of input unit that is con- of input unit that is con- input unit that is con-
nected to each INPUT nected to each INPUT nected to each OUTPUT
connector (1–10) of the connector (1–10) of the connector (1–6) of the
engine. engine. engine.
23