Yamaha CS1D Owner's Manual page 146

4. In the LCD FUNCTION ACCESS block, press the
INPUT [PATCH] switch several times to access the
following INSERT/DIRECT OUT screen (IN
PATCH function).
In the INSERT/DIRECT OUT screen (IN PATCH
function) you can switch insertion on/off for each
input channel. Here you can also select the insert I/O
point (the position at which the external device is
inserted), and the direct out point (the position from
which direct output is taken).
Hint
You can also turn insert on/off in the SELECTED
INPUT CHANNEL block.
Number of the input channel
Short name of the input
channel
Hint
You can also access the INSERT/DIRECT OUT
screen (IN PATCH) by clicking the INSERT/DIRECT
POINT tab in step 3.
5. Click the INS. button for the desired channel to
turn it on.
Insert will be enabled for the corresponding channel.
6. Click one of the following buttons to select the
desired INSERT I/O POINT.
PRE EQ ...............Immediately before the EQ
POST EQ ............Immediately after the EQ
PRE COMP.........Immediately before the com-
pressor
PRE DELAY ........Immediately before the delay
PRE FADER........Immediately before the fader
7. In the LCD FUNCTION ACCESS block, press the
INPUT [HA/INSERT] switch.
The IN HA/INSERT function screen will appear.
This contains mainly input card preamp settings (A/
B selection, gain adjustment, etc.).
Turn insert on/ Specify the insert I/O point for
off for each each channel.
channel.
Chapter 6. Insert and direct out
INSERT/DIRECT OUT screen (IN PATCH func-
tion)
Specify the direct out point for
each channel
IN HA/INSERT function screen
87