Mode); Connecting A Digital Input/Output Unit To The Engine (Standard Mode) - Yamaha CS1D Owner's Manual

Connecting a digital input/output unit to the engine (Standard

mode)

When connecting a DIO8 digital input/output unit to the engine in Standard mode, the method will depend on whether
you use only slots 1–4 (of the DIO8's slots 1–8) or slots 1–4 as well as slots 5–8.
1 If input/output cards are installed only in DIO8
slots 1–4
The following diagram shows example connections
for when input/output cards are connected only to
slots 1–4 of the DIO8.
ENGINE A
(DSP1D-EX{DSP1D})
INPUT 1
OUTPUT A
DIO8 (ID=1)
PORT B SELECTOR=5–8
Connect the OUTPUT A connector of the digital
input/output unit to one of the INPUT 1–10 connec-
tors of the engine, and connect the INPUT A connec-
tor of the digital input/output unit to one of the
OUTPUT 1–6 connectors of the engine. In this case,
set the PORT B SELECTOR switch (located on the
front panel of the DIO8) to the 5-8 position.
OUTPUT 1
INPUT A
Connections (Standard mode)
2 If input/output cards are also installed in DIO8
slots 5–8
The following diagram shows example connections
for when input/output cards are installed in DIO8
slots 1–4 and also in slots 5–8.
INPUT 1
ENGINE A
(DSP1D-EX{DSP1D})
INPUT 2
A B
OUTPUT
DIO8 (ID=1)
PORT B SELECTOR=5–8
Connect the OUTPUT connectors A/B of the digital
input/output unit to the INPUT 1–10 connectors of
the engine, and connect the INPUT connectors A/B
of the digital input/output unit to OUTPUT 1–6
connectors of the engine. In this case, set the PORT B
SELECTOR switch (located on the front panel of the
DIO8) to the 5-8 position.
Hint
The DIO8 digital input/output unit can be con-
nected to any INPUT connector/OUTPUT connec-
tor of the engine. The DIO8 will automatically select
a control connector according to the status of con-
nections, and the connector number of the engine
connected to that connector will be displayed in the
LED display as the unit ID. In the example shown
above, the INPUT 1 connector number is the unit ID
number.
Be careful not to connect inputs and outputs in
reverse. If such a connection is made, the unit will
not be recognized and cannot be controlled.
When using an MY8-AT card to handle ADAT for -
mat signals, synchronization may tend to be lost
easily, depending on the device that is connected.
For more reliable synchronization, we recommend
that the word clock for the combination of digital
audio equipment you are using be taken from other
than the ADAT format connector.
OUTPUT 2
OUTPUT 1
A B
INPUT
9