Yamaha CS1D Owner's Manual page 245

CS1D Reference Manual (Hardware)
The current value is shown by the [VALUE] indica-
tor. (Either the [msec] or [sec] LED will light to indi-
cate the units of the displayed value.)
9 NOISE GATE [GR] meter LEDs
This meter shows how far the noise gate has closed.
Hint
In the UTILITY function PREFERENCE screen you
can specify whether the GR meter display will be
linked with the noise gate on/off setting. If linking is
on, the GR meter will be displayed only when the
noise gate is on; the meter will not be displayed when
the noise gate is off. If linking is turned off, the GR
meter will always be displayed.
0 NOISE GATE [POST] meter LEDs
This meter indicates the signal level after passing
through the noise gate.
A NOISE GATE [LINK] switch and LED
This specifies whether noise gate operation of adja-
cent odd-numbered
nels will be linked by a key-in signal (link=on) or
whether the noise gate will operate using indepen-
dent key-in signals (link=off). (The LED will light
when link is on.)
Key-in signal flow when link=on
LINK = ON
THR
Key-in signal of odd-
numbered channel
THR
Key-in signal of even-
numbered channel
Key-in signal flow when link=off
LINK = OFF
THR
Key-in signal of odd-
numbered channel
THR
Key-in signal of even-
numbered channel
Linking will occur only if channels of the same
NOISE GATE type are linked. If channels with dif-
fering types are linked, the operation will be the
same as if link is off.
Be careful not to confuse "noise gate linking" with
"input channel pairing."
Turning noise gate link on will simply cause the two
noise gates to be triggered by the same key-in sig-
nal; the parameters of the noise gates themselves
can be set independently for each channel.
If two input channels are paired, noise gate link will
automatically be turned on, and the noise gate
parameters will also operate in tandem. However,
you are free to subsequently turn linking off.
For a ST IN channel, the noise gate parameters for
the left and right channels will always operate in
tandem. However, you are free to turn link on/off.
28
even-numbered input chan-
ATTACK
Detect the processing
maximum
level ATTACK
processing
ATTACK
Detect the
maximum level processing
Detect the ATTACK
maximum level processing
B NOISE GATE [ON] switch and LED
This switch turns the internal noise gate on/off.
When the noise gate is on, the switch LED will light.
C NOISE GATE [RANGE] encoder and LEDs
This encoder sets the RANGE parameter of the inter-
nal noise gate.
The approximate current value is shown by the
perimeter LEDs.
The range is –70 dB–0 dB (1 dB units).
D NOISE GATE [THR] encoder and LEDs
This encoder sets the THRESHOLD parameter of the
internal noise gate.
The approximate current value is shown by the
perimeter LEDs.
The range is –54 dB–0 dB (1 dB units).
GR
GR
GR
GR