Yamaha CS1D Owner's Manual page 374

The LED of a USER DEFINE switch to which this
function is assigned will light when the currently
selected monitor source matches the parameter.
When you use the USER DEFINE [1]–[8] switches
to change the monitor source, the MONITOR A
SOURCE switch and MONITOR B SOURCE
switch of the CS1D will have no effect until the next
time you select the monitor source from the panel.
PAGE SELECT (parameter: PREVIOUS, NEXT,
LAST)
Access the specified screen in the display.
PREVIOUS: The last-selected screen within the same
function will be displayed.
NEXT: The next screen within the same function will
be displayed.
LAST: The last-selected screen will be displayed once
again.
BOOKMARK
Access the screen that was last bookmarked. The LED
of a USER DEFINE switch to which this function is
assigned will light when a screen has been memo-
rized. Also, when the functions of the USER DEFINE
[1]–[8] switches are shown at the bottom of the dis-
play, the name of the screen memorized as a book-
mark will be displayed at the location of the
corresponding switch.
To register a screen, press and hold the correspond-
ing USER DEFINE switch for two seconds or longer.
If you release your hand in less than two seconds, the
last-registered screen will be recalled.
[Procedure]
Assigning a function to the USER DEFINE [1]–[8]
switches
1. Access the UTILITY function USER DEFINE
screen.
2. From the USER DEFINE [1]–[8] switches, select the
switch to which you wish to assign a function, and
click the button for that number.
The following USER DEFINE KEY SETUP popup
window will appear.
3. From the list in the FUNCTION section, select the
function that you wish to assign.
4. As necessary, click a button in the PARAMETER
section to select the parameter.
5. Click the OK button.
6. Repeat steps 2–5 until you have assigned the
desired functions to the USER DEFINE [1]–[8]
switches.
7. To execute an assigned function, press one of the
USER DEFINE [1]–[8] switches in the USER
DEFINE block.
Hint
The functions assigned to the USER DEFINE [1]–[8]
switches can also be executed in the display. To do so,
click the USER DEFINE button located at the lower
left of the screen to display the USER DEFINE 1–8
buttons, and click the desired button.
USER DEFINE buttons
Display the USER DEFINE 1–8 buttons in the lower
part of the screen
UTILITY functions
39