Pairing Matrix Channels - Yamaha CS1D Owner's Manual

CS1D Operating Manual (Basic Operation)
Hint
The detection point (metering point) shown in the
meters can be specified in greater detail. For details
refer to the section "Setting the metering point" in
"Chapter 16. Various settings."

Pairing MATRIX channels

Adjacent odd-numbered
will be linked for the two paired channels.
[Procedure]
1. In the MATRIX OUTPUT block, hold down the
[SEL] switch for one of two adjacent odd-num-
bered even-numbered MATRIX channels, and
then press the other [SEL] switch.
The direction in which the channel parameters are
copied will depend on the order in which the [SEL]
switches are pressed. When you create a pair, the
parameters of the channel you pressed first will be
copied to the channel that you pressed next, and will
subsequently be linked.
For example if you pair MATRIX 1 and MATRIX 2,
holding down the MATRIX 1 [SEL] switch and then
the MATRIX 2 [SEL] switch will cause the state of
MATRIX 1 to be copied to MATRIX 2. For details on
the parameters that are copied/linked when paired,
refer to "CS1D Reference Manual (Appendices)"
( p.45).
If you wish to reset the parameters, do so from the
screen.
When MATRIX channels are paired, the functions of
the controllers on the CS1D console and the parame-
ters in the display will change as follows.
MATRIX OUTPUT block
If MATRIX channels are paired, the left (odd-num-
bered) encoder will function as a [BAL] encoder to
set the volume balance between the two MATRIX
channels, and the right (even-numbered) encoder
will function as a [LEVEL] encoder for both
MATRIX channels.
The operation of other adjacent odd-numbered
even-numbered switches will also be linked.
70
even-numbered MATRIX channels can be paired. All parameters except for pan and delay
When MATRIX channels are not paired
MATRIX
channel 1
ON
OUTPUT
LEVEL
MATRIX CHANNEL
OUTPUT LEVEL
MATRIX 1
OUTPUT LEVEL
MATRIX 2
MATRIX
channel 2
ON
OUTPUT
LEVEL
PAIR
ON
ON