Output Section - Yamaha CS1D Owner's Manual

9 EQ [ ] switch & LED (SUB LOW band only)
This switch changes the SUB LOW band EQ type to
low shelving.
When you switch the type to low shelving, the switch
LED will light.

OUTPUT section

This section switches the currently selected output channel on/off, and adjusts the pan/balance and level of the output
signal.
1 OUTPUT [ON] switch and LED
This switch turns the currently selected channel on/
off. (When on, the LED will light.)
2 OUTPUT [INSERT] switch and LED
This switch turns insertion on/off for the currently
selected channel.
When insertion is on, the switch LED will light, and
the insert out/in points specified in the display
(OUTPUT PATCH function INSERT PATCH screen)
will be enabled.
If the [INSERT] switch is turned on when the insert
out/in points are not patched to appropriate jacks,
it is possible that no signal will be output from the
channel of the output unit patched to that channel.
Please use caution.
3 OUTPUT [TO ST] switch and LED
When a MIX channel is selected, this is an on/off
switch for the signal sent from that MIX channel to
the STEREO bus. (When on, the LED will light.)
This is linked to the MIX [TO ST] switch of the MIX
OUTPUT block.
This switch is valid only if a MIX channel is selected
in the SELECTED OUTPUT CHANNEL block.
1 2
ON
INSERT
5
L R
6
TO ST PAN BAL
4 OUTPUT [TO MTRX] switch and LED
5 OUTPUT [PAN/BAL] encoder and LEDs
SELECTED OUTPUT CHANNEL block
In this case, the SUB LOW band [Q] encoder will
have no function, and its peripheral LEDs will go
dark.
3 4
TO ST TO MTRX
7
LEVEL
0 10
8
CUE
When the STEREO A, B channel or a MIX channel
1–48 is selected, this is an on/off switch for the signal
sent from that channel to the MATRIX bus. (When
on, the LED will light.)
When this switch is off, no signal can be sent from
that channel to any MATRIX bus.
This is linked with the MIX OUTPUT block MIX
[TO MTRX] switch and the STEREO OUTPUT
block STEREO A [TO MTRX] switch.
The send level settings can be made in the display.
This switch is valid only when the STEREO A, B
channel or a MIX channel is selected in the
SELECTED OUTPUT CHANNEL block.
This encoder adjusts the pan or balance, according to
the group or pair on/off status of the currently
selected output channel.
The approximate current setting is shown by the
perimeter LEDs.
63