Yamaha CS1D Owner's Manual page 468

2 A/B LINK
For adjacent input channels on the screen, this but-
ton links the selection of input jacks A/B on an AD
card with head amp. If this button is on, switching
the A/B button (4) for one channel will force the
same button to be selected for the other channel as
well.
If an AD card with head amp is patched to multiple
channels, switching the A/B setting of a channel for
which A/B LINK is on will cause A/B to change in the
same way for all patch destination channels.
In addition, if there are any channels that are linked
to the patch destination channel, they will be
switched in the same way.
3 Level meter
This is a peak level meter showing the input level.
4 A/B
This button switches between input jacks A/B of the
AD card with head amp.
5 +48 V
For each channel, this button switches the phantom
power on/off for the AD card with head amp.
The +48V switch on the front panel of the AI8
input unit is the master phantom power switch for
the entire unit. If this switch is off, phantom power
cannot be used on that unit (regardless of the set-
ting of the +48V button in the display).
6 ø (phase)
This button switches the input signal between nor-
mal and inverted phase.
7 GAIN
This knob adjusts the input sensitivity of the head
amp. It covers a range of +10dB — –68 dB, and the
current value is displayed in the numerical box
immediately below the knob.
The PAD will be internally switched on or off when
the gain of the LMY4-MLF card (including the AI8-
ML8F unit) internal head amp is adjusted between
–8 dB and –7 dB. Keep in mind that noise may be
generated if there is a difference between the Hot
and Cold output impedance of the external device
connected to the card when using phantom power.
8 Unit type/ID number/channel number
This displays the input unit type and ID number, slot
number, and input jack channel number.
9 Pair setting
This displays the input channel number and the pair-
ing status. You can click the heart symbol to select/
defeat pairing.
0 Digital I/O card
If a digital I/O card is installed in the digital input/
output unit, the type of digital I/O card will be
shown here.
IN HA/INSERT (Input head amp/insert) functions
A DE-EMPHASIS
If a signal with emphasis (emphasis = ON) is input
to the corresponding port of the digital input/output
unit, this area will indicate "DE-EMPHASIS."
B UNIT LIBRARY
This button accesses the UNIT LIBRARY window in
which preamp settings for all units can be stored/
recalled (→p.170). This button will be displayed only
when the ST IN INS tab is selected.
B
133