Checking The Status Of Each Device (Standard Mode); Checking The Engine (Standard Mode) - Yamaha CS1D Owner's Manual

If the opening screen is followed by the "VERSION CHECK" popup window, it is possible that the PM1D system
version is incorrect. Please unify the software version of all connected devices. For the procedure, refer to the expla-
nation within the included PM1D System Software disc.
Hint
Normally, the display will show the screen that was accessed last when the power was turned off.

Checking the status of each device (Standard mode)

x1 x1
DSP
After you turn on the power of the PM1D system, you can use the LEDs and indicators of the various components to
check that connections between components have been made appropriately. Check the status of each device as described
below.
The checking method differs between Standard mode and Mirror mode. This section describes checking for Standard
mode.
For Mirror mode, refer to "Checking the status of each device (Mirror mode)" ( p.18).

Checking the engine (Standard mode)

The front panel of the DSP1D-EX {DSP1D} engine shows the following information.
1 ENGINE ID
These indicators show whether the engine (DSP1D-
EX {DSP1D}) is connected to the ENGINE A or
ENGINE B connectors (DIGITAL I/O, CONTROL I/
O) of the console. In Standard mode, the A LED will
always be lit.
2 CONTROL I/O
If the CONTROL I/O connectors of the engine and
console are connected correctly, the LED for the cur-
rently-valid CONTROL I/O connector (either 1 or 2)
will light.
3 INPUT CONFIGURATION
This indicates the number of monaural input chan-
nels that can be used on this engine. If the engine is
the DSP1D-EX, the "96CH" LED will light. {For the
DSP1D, the "48CH" LED will light.}
For details on the lit/dark status of each indicator,
refer to the operating manual included with the
DSP1D-EX {DSP1D}.
Turning on the power and verifying the connections
ENGINE ID
ENGINE ID
A B
CONTROL I/O
A B
1 2
INPUT
CONFIGURATION
48CH 96CH
POWER
ON/ OFF
CONTROL I/O
1 2
INPUT
CONFIGURATION
48CH 96CH
1
2
3
15