Chapter 6. Insert And Direct Out; Insert; Connecting The External Device To Be Inserted - Yamaha CS1D Owner's Manual

Chapter 6. Insert and direct out

This chapter explains how external devices such as effect processors can be inserted into a specific channel, and how the
signal of an input channel can be directly output from a desired output jack.

Insert

An external device such as an effect processor can be inserted in an input channel/output channel of the PM1D system.

Connecting the external device to be inserted

To insert an external device into a specific channel, you will use the output jack and input jack of an output unit as the
insert out/insert in jacks respectively.
The following diagram shows typical connections for insertion.
Example connections for insertion 1
DA card
LMY4-DA
1 2 3 4 5 6
AO8 analog output unit
L R
88
Effect processor
1 2 3 4 5 6
AI8 analog input unit
AD card
LMY4-AD
7 8
OUTPUT UNIT NO.
INPUT SELECTOR
A
B
POWER
ON/ OFF
ANALOG OUTPUT BOX
7 8
INPUT UNIT NO.
PHANTOM MASTER
ON
+48V
OFF
POWER
ON/ OFF
ANALOG INPUT BOX
Example connections for insertion 2
Digital I/O card
DIO8 digital input/output
unit
DIGITAL DIGITAL
IN OUT
88
Effect processor
If an external digital device is inserted via a digital
I/O card as shown in "Example connections for
insertion 2," the word clocks of the PM1D system
and the digital device must be synchronized. Nor-
mally, we recommend that you set the digital device
as the slave, so that it will synchronize to the word
clock of the PM1D. (For details on setting it to slave
mode, refer to the manual for your device.)
I/O UNIT ID
PORT B SELECTOR
5-8
1-4
POWER
ON/ OFF
85