Lcr - Yamaha CS1D Owner's Manual

Input functions

LCR

[Function]
Make settings for LCR mode to allow three-channel playback, with a CENTER channel added to the L/R
channels of the STEREO bus.
Console
In the LCD FUNCTION ACCESS
block, press the INPUT [PAN/
ROUTING] switch (press repeatedly
until the screen shown at the right
appears)
Display
MENU button INPUT PAN/
ROUTING button LCR tab
[Screen functions]
2
1 CENTER BUS CONTROL
When this button is on, the STEREO B channel will
function as the CENTER channel.
By adding the CENTER channel to the L/R channels
of the STEREO A bus, you can implement three-
channel playback.
160
1
4 3
When this button is off, the CENTER channel sig-
nal will no longer be sent to STEREO B, meaning
that it will not be output externally. (The same LR
signal as STEREO A will be sent to STEREO B.)
However even when the CENTER BUS CONTROL
button is off, you can operate LCR pan for channels
in which LCR mode is turned on. (When you turn
the button on, the LCR setting will immediately
take effect.)
2 LCR (LCR mode on/off)
For each input channel/ST IN channel, turn LCR
mode on/off.
For channels whose LCR mode is on, you can use the
INPUT [PAN] encoder on the CS1D top panel to
simultaneously control the level of the L/R channels
and the CENTER channel.
Hint
On channels for which LCR mode on, rotating the
[PAN] encoder will cause the perimeter LEDs to light
as follows.