Stereo Section - Yamaha CS1D Owner's Manual

CS1D Reference Manual (Hardware)

STEREO section

In this section, the signal that is sent from the currently selected channel to the STEREO bus can be switched on/off and
panned.
1 STEREO [FIXED MIX PAN] switch and LED
When the signal from the currently selected channel
is sent to a FIX type MIX bus, this switch specifies
whether the signal from before or after the [PAN]
encoder (3) will be sent.
When this switch is on (LED lit), the signal after the
[PAN] encoder will be sent.
The setting of this switch applies to all FIX type MIX
buses.
Signal flow when the [FIXED MIX PAN] switch is
off
INPUT CHANNEL
FADER
PAN
ON
MIX1 (TYPE=FIX)
MIX2 (TYPE=FIX)
Signal flow when the [FIXED MIX PAN] switch is
on
INPUT CHANNEL
FADER
PAN
ON
30
1
......
......
ON
ON
......
......
MIX1
(TYPE=FIX)
ON
ON
MIX2
(TYPE=FIX)
2 3
STEREO
2 STEREO [TO ST] switch and LED
This is an on/off switch for the signal that is sent
from the currently selected channel to the STEREO
bus. (When on, the LED will light.)
This switch does not affect the signals that are sent
from the channel to the MIX buses.
3 STEREO [PAN] encoder and LEDs
This encoder sets the panning of the signal that is
sent from the currently selected channel to the STE-
REO bus.
The approximate current setting is shown by the
perimeter LEDs.
When the LED at the
panned to the center.
Hint
For two paired channels, or for a ST IN channel, the
pan is set independently for each channel.
If the STEREO [FIXED MIX PAN] switch (1) is
turned on, the setting of the STEREO [PAN] encoder
will be valid for FIX type MIX buses as well.
mark is lit, the signal is