Yamaha CS1D Owner's Manual page 94

ST IN block
ST IN STATUS [L]/[R] LEDs
These LEDs indicate which channel (L or R) is cur-
rently displayed by this ST IN channel module.
ST IN [MIX] encoder and LEDs
This encoder sets the send level of the signal that is
sent from the ST IN channel to a VARI type MIX bus.
The peripheral LEDs will light to indicate the approxi-
mate current value.
ST IN MIX [ON] LED
This LED indicates the on/off status of the signal that is
sent from the ST IN channel to the MIX bus.
ST IN [PAN] encoder and LEDs
This encoder sets the stereo position of the signal that is sent
from the ST IN channel to the STEREO bus. The approximate
current value is shown by the perimeter LEDs.
ST IN [TO ST] switch and LED
This is an on/off switch for the signal that is sent from
the ST IN channel to the STEREO bus.
ST IN [GAIN] encoder and LEDs
This encoder adjusts the input sensitivity of the head
amp for a ST IN channel to which a mic/line input card
(LMY2-ML) has been patched. The peripheral LEDs
will light to indicate the approximate current value.
ST IN [CLIP] LED
This LED will light when the input signal clips for that
ST IN channel.
ST IN SEL [L]/[R] switches and LEDs
These switches select the channel (L or R of the corre-
sponding ST IN channel) that will be controlled in the
SELECTED INPUT CHANNEL block and in the display.
For a ST IN channel, the L/R channel parame-
ters will generally operate in tandem. For this
reason, using the ST IN SEL [L]/[R] switches to
select either L or R and moving the encoders
and fader of the ST IN block will cause the other
channel (R or L) to change accordingly.
However, head amp parameters and pan/delay
related parameters must be set independently.
ST IN [ON] switch and LED
This turns the ST IN channel on/off. If this switch is
turned off, no signal will be sent from this ST IN chan-
nel to the STEREO bus or MIX buses.
ST IN fader
This is a 100 mm fader that adjusts the input level
of the ST IN channel.
Chapter 4. Basic operation for input channels
L STATUS R
MIX
0 10
ON
ST IN [+48V]/[INS]/[ø] LEDs
These respectively indicate the on/off status of
PAN
phantom power, insertion, and phase.
L R
+48V
ST IN [A]/[B] LEDs
INS A
B For a ST IN channel to which a mic/line input card
TO ST
INPUT
(LMY2-ML) has been patched, these indicate
whether input jack A or B is enabled.
GAIN
+10 -68
COMP [+]/[THR]/[–] LEDs
L CLIP R
These LEDs show the operating status of the inter-
+
nal compressor. For details on the meaning of each
THR
L
-
LED, refer to "CS1D Reference Manual (Software)."
SEL COMP
GATE [+]/[THR]/[–] LEDs
+
These LEDs show the operating status of the inter-
THR
R
nal noise gate. For details on the meaning of each
-
SEL GATE
LED, refer to "CS1D Reference Manual (Software)."
ST IN [NAME] indicator
This shows the short name of the ST IN channel.
CLIP
Meter LEDs
6
ON
These are six-point LED meters that independently
12
18
indicate the L and R input levels of the ST IN chan-
30
nel.
60
DCA
10
1
2
3
4
5
5
6
0
7
8
9
5
10
11
12
10
20
RCL
MUTE
30
SAFE
40
50
60
35