Yamaha CS1D Owner's Manual page 42

CS1D Operating Manual (Start-up)
Number of
the patch
destination
input chan-
nel.
Hint
The switches in the LCD FUNCTION ACCESS block
are used to access the desired function in the display.
Each function is divided into multiple screens, and
you can press the same switch repeatedly to cycle
through the displayed screens.
3. Move the left/right scroll bar so that the visible area
of the horizontal rows (patch source) shows the
input unit to which the input source is connected.
Use the left/right scroll bar to access input units that
are not currently shown in the visible area.
Click the / buttons to
switch the display in steps of a
unit.
Click the / buttons to
switch the display in steps of a
slot.
4. Patch the input source to input channels 1/2.
In the IN PATCH screen, the jack to which the input
source is connected can be patched to the desired
input channel by making a
grid where the patch source intersects the patch des-
tination. There are two ways to do this, as follows.
34
In this grid, input jacks (horizontal rows) can be patched to input channels (vertical col-
umns). A symbol is displayed to indicate a currently-patched grid location.
Drag this box to move the
displayed area to left or
right.
symbol appear in the
You can also click this area to
move the displayed portion.
Patch source
input jack.
From the top
row, the dis-
play shows
the type and
ID of the input
unit, the num-
ber of the slot
in which the
input card is
installed, and
the number of
the channel
(jack) within
the card.
Click the / buttons
to switch the display in steps
of a unit.
Click the / buttons
to switch the display in steps
of a slot.