Yamaha CS1D Owner's Manual page 233

CS1D Reference Manual (Hardware)
When the compressor type is COMPANDER
COMPANDER
Level
ATTACK
ATTACK
[+]
[–] [THR]
* Each of the above diagrams shows the example of
using the ST IN channel itself as the key-in signal
for the compressor.
Hint
The compressor on/off status and its parameters can
be set in the SELECTED INPUT CHANNEL block,
or in the display (IN GATE/COMP function COMP
PRM screen).
C ST IN GATE [+]/[THR]/[–] LEDs
These LEDs indicate the operating status of the inter-
nal noise gate. If the noise gate is turned off, all LEDs
will be dark.
If the noise gate is turned on, one of the LEDs will
light to indicate the currently selected type and oper-
ating status of the noise gate.
When the noise gate type is GATE
GATE
Level
ATTACK
[–] [THR] [+]
When the noise gate type is DUCKING
DUCKING
Level
ATTACK
[–] [THR] [+]
* Each of the above diagrams shows the example of
using the ST IN channel itself as the key-in signal
for the noise gate.
16
Key-in signal
Output signal
RELEASE
Threshold level
WIDTH
RELEASE
Time
[THR] [–]
Key-in signal
Output signal
HOLD
Threshold level
Time
[THR] [–]
Key-in signal
Output signal
HOLD
Threshold level
Time
[THR] [–]
Hint
The noise gate on/off status and its parameters can
be set in the SELECTED INPUT CHANNEL block,
or in the display (IN GATE/COMP function GATE
PRM screen).
D ST IN SEL [L]/[R] switches and LEDs
These switches select the ST IN channel to which
your operations will apply.
You can select either the L or the R channel. The LED
of the currently selected channel will light, and the
LED of the other channel will blink.
The channel selected by these switches can be
adjusted by the SELECTED INPUT CHANNEL
block, and will be reflected by the contents of the dis-
play screen.
E ST IN [NAME] indicator
This displays the short name of the ST IN channel.
The short name can be input in the display (IN
PATCH function NAME screen, etc.).
F L/R meter LEDs
These six LEDs indicate the input level of the ST IN
channel.
The position at which the level is detected can be
selected from the following locations: PRE ATT.
(before the attenuator), PRE GATE (immediately
before the internal noise gate), PRE FADER (imme-
diately before the fader), POST FADER (immediately
after the fader), or POST ON (immediately after the
[ON] switch).
The level detection point can be selected in the dis-
play (METER function).
The peak level of this meter will not be held even if
the [PEAK HOLD] switch is turned on in the
METER section (MASTER block).
G ST IN [ON] switch and LED
This switches the on/off status of the ST IN channel.
(This LED will be lit for ST IN channels that are
turned on.)
If this switch is turned off, no signal will be sent from
that ST IN channel to the STEREO bus or MIX
buses.