Using The Solo Function - Yamaha CS1D Owner's Manual

Using the Solo function

Here's how to use the Solo function of the PM1D.
[Procedure]
1. Use the [LAST CUE] switch of the CUE section to
select either LAST CUE mode ([LAST CUE] switch
on) or MIX CUE mode ([LAST CUE] switch off) as
the mode of operation when two or more [CUE]
switches within the same group are pressed.
2. Turn on the [SOLO] switch of the CUE section for
two seconds or longer.
Solo mode will be selected. In Solo mode, only the
signal of the channel/DCA group whose [CUE]
switch was pressed will be output to the MIX,
MATRIX, and STEREO buses. The same signal can
also be monitored from MONITOR OUT jacks A,
the PHONES MONITOR A jack, and the CUE OUT
jacks.
3. If you wish to exclude only a specific channel from
the Solo operation, press the [MON/CUE] switch
(located in the LCD FUNCTION ACCESS block)
several times to access the following CUE/SOLO
screen.
LCD FUNCTION ACCESS
block
CUE/SOLO screen (MON/CUE function)
[MON/CUE] switch
4. In the SOLO SAFE section of the CUE/SOLO
screen, select the channel(s) that you wish to
exclude from the Solo operation. (You may select
more than one.)
Channels that are selected in the SOLO SAFE section
will not be muted in Solo mode. For example, this is
a convenient way to avoid soloing channels that must
not be soloed accidentally, such as the main STEREO
channel or MIX channels that are sending signals to
an external recorder.
Each button corresponds to the following channels.
INPUT 1–96 {1–48}. Input channels 1–96 {1–48}
ST IN 1–8 {1–4} ....... ST IN channels 1–8 {1–4}
MIX 1–48 ................. MIX channels 1–48
MATRIX 1–24.......... MATRIX channels 1–24
STEREO A/B............ STEREO A/B channels
5. Turn on the [CUE] switch of the desired channel/
DCA group.
Only the signal of the corresponding channel/DCA
group will be sent to the various buses, and other
channels/DCA groups will be muted. The same sig-
nal will also be output from MONITOR OUT jacks
A, the PHONES MONITOR A jack, and the CUE
OUT jacks.
6. To defeat Solo, press the currently-on [CUE]
switches once again.
Hint
When you press the [LAST CUE] switch to change
from LAST CUE mode to MIX CUE mode (or vice
versa), the previously-valid cue (solo) will be can-
celled.
Normally, cue/solo operations can be performed
independently of the scene memory. However if you
recall a scene that causes a channel to switch from
monaural to paired, both channels will be turned on
if either of the two channels had been set to Cue/Solo
On until then.
Chapter 10. Monitor
119