Yamaha CS1D Owner's Manual page 231

CS1D Reference Manual (Hardware)
1
L
2
3
0
ON
4
L
5
TO ST
0
A
+10
L
1 ST IN STATUS [L]/[R] LEDs
These LEDs indicate whether this ST IN channel
module currently shows the right or the left channel.
When the [L] LED is lit, the module shows the status
of the left channel. When the [R] LED is lit, the mod-
ule shows the status of the right channel.
Hint
The two-channel signal that is patched to the ST IN
channel will be processed as a pair, all parameters
will be linked except for the head amp settings (A/B
channel selection, phantom power on/off, gain
adjustment), and pan and delay.
2 ST IN [MIX] encoder and LEDs
When a VARI type MIX bus is selected, this encoder
sets the send level of the signal that is sent from the
ST IN channel to that MIX bus.
The range is – dB – +10 dB, and the approximate
current value is shown by the perimeter LEDs. When
the LED for the mark is lit, the level is nominal (0
®
dB).
However if a FIX type MIX bus is selected, the ST IN
[MIX] encoder will have no effect, the LEDs will
remain dark even if the encoder is operated
Hint
To select the MIX bus that will be the send destina-
tion of the ST IN channel, use the MIX OUTPUT
block MIX [SEL] switch, or the SELECTED OUT-
PUT CHANNEL block CHANNEL SELECT [ /
DEC]/[ /INC] switches.
3 ST IN MIX [ON] LED
This indicates the on/off status of the signal that is
sent from the ST IN channel to the currently selected
MIX bus. (The LED will light when on.)
14
STATUS R
MIX
10
PAN
6
R
7
+48V
INS A 9
B
INPUT
8
GAIN
-68
CLIP R
The on/off setting can be switched from the console
in the SELECTED INPUT CHANNEL block, or in
the display (PAN/ROUTING function CH to MIX
screen/MIX ASSIGN screen).
You can set the FADER [FLIP] switch in the
SELECTED INPUT CHANNEL block to exchange
(flip) the function of the ST IN [MIX] encoder (2)
and the ST IN fader (H). ( p.36)
4 ST IN [PAN] encoder and LEDs
This encoder sets the panning of the signal that is
sent from the ST IN channel to the STEREO bus.
The approximate current setting is shown by the
perimeter LEDs. When the LED at the
the pan is at the center.
As shown below, the perimeter LEDs will light differ-
ently, depending on whether LCR mode (a function
that allows three-channel playback with a CENTER
channel added to the L/R channels) is on or off.
(LCR mode can be turned on/off in the PAN/ROUT-
ING function LCR screen.)
When LCR=off
PAN
L R
When LCR=on
PAN
L R
Hint
This parameter can be adjusted independently for
left and right channels.
5 ST IN [TO ST] switch and LED
This is an on/off switch for the signal that is sent
from the ST IN channel to the STEREO bus. (The
LED will light when this is on.)
This switch does not affect the signal that is sent
from the ST IN channel to the MIX buses.
6 ST IN [+48V] LED
This LED will light if an AD card with head amp is
patched to the ST IN channel, and the phantom
power is on.
This will be dark if a different type of card is patched,
or if phantom power is off.
Hint
This parameter can be set independently for left and
right channels.
mark is lit,
PAN PAN
L R L
PAN PAN
L R L
R
R