Dca Section - Yamaha CS1D Owner's Manual

DCA section

This section assigns the currently selected MIX channel to a DCA group. If you wish to assign a single MIX channel to
multiple DCA groups, it is convenient to use this section.
1 DCA [9]–[12] switches and LEDs
These switches assign the currently selected MIX
channel to DCA groups 9–12.
When the channel is assigned to a DCA group, the
LED of the corresponding switch will light.
This section is valid only when a MIX channel 1–48
is selected.
SELECTED OUTPUT CHANNEL block
1
9
10
11
12
DCA
[Procedure]
Using the SELECTED OUTPUT CHANNEL block
to assign a MIX channel to a DCA group
1. Select the MIX channel that you wish to assign to a
DCA group (9–12).
2. Use the SELECTED OUTPUT CHANNEL block
DCA [9]–[12] switches to select the DCA group(s)
that you wish to assign to the channel. (You may
select more than one.)
The LED for the selected DCA group(s) will light.
DCA groups 9–12 can be used for either input chan-
nels or output channels (MIX channels).
However, it is not possible to assign both input chan-
nels and output channels to the same DCA group.
For this reason, if a input channel is already assigned
to DCA group 9–12, attempting to assign a MIX
channel will cause a message to be displayed, and you
will not be able to do so.
When a scene is recalled, the DCA group data of
recall safe channels may be adjusted so that recall safe
settings are consistent within DCA groups 9–12.
Also when a channel library is recalled, the data
recalled to a channel may be adjusted so that settings
are consistent within DCA groups 9–12.
65