Yamaha CS1D Owner's Manual page 252

This function is convenient when you wish to quickly
select an input channel that is at the same position of
another INPUT block.
4 [CHANNEL COPY] switch and LED
This switch is used to copy parameters from the
desired input channel to another input channel.
When you press this switch, the currently selected
input channel will be the copy source, and the input
channel whose [SEL] you press immediately thereaf-
ter will be the copy destination.
[Procedure]
Copying the input channel/ST IN channel
parameters to another channel
1. Select the input channel or ST IN channel that will
be the copy source.
2. Press the [CHANNEL COPY] switch.
The [CHANNEL COPY] switch LED will light.
However if you do not specify the copy destination
within ten seconds, the copy operation will be can-
celled.
3. Press a [SEL] switch to select the copy destination
input channel or ST IN channel.
A popup window will appear, asking you to confirm
the copy operation.
4. To execute the copy operation, click the OK button.
To cancel the copy operation, click the CANCEL
button.
Hint
For details on the types of parameter that are copied
when you copy between input channels, refer to the
appendices ( p.44).
If you wish to perform another copy, repeat steps 1–
4.
Copying is possible only between monaural input
channels or stereo input channels (a ST IN channel
or two paired channels). If you attempt to copy
some other combination of channels, a message of
"DATA TYPE CONFLICT! CANCELED" will
appear, and copying will not occur.
It is not possible to use the [ /DEC]/[ /INC]
switches to select the copy destination channel. The
channel copy operation will be cancelled.
SELECTED INPUT CHANNEL block
35