Yamaha CS1D Owner's Manual page 271

CS1D Reference Manual (Hardware)
3 STEREO B [MONO] switch and LED (STEREO B
channel only)
This switch selects monaural or stereo output for the
STEREO B channel.
When the LED is lit, the output of the STEREO B
channel will be monaural, and the same signal will be
output to the channels of the output units that are
patched to STB (L) and STB (R).
In this case, the signals of the left and right channels
will be mixed with a 3 dB attenuation.
Hint
The signal that is sent from STEREO B to the
MATRIX bus can be switched on/off in the LCD
screen.
4 STEREO [SEL] switch and LED
This switch selects the STEREO A/B channel to
which your operations will apply.
When you press this switch, the STEREO A or STE-
REO B channel can be controlled in the SELECTED
OUTPUT CHANNEL block.
This will also be reflected by the settings in the dis-
play.
Hint
Each time you repeatedly press the STEREO [SEL]
switch, you will alternate between the L channel and
R channel of STEREO A or STEREO B.
For example if you repeatedly press the STEREO A
channel [SEL] switch, the CHANNEL SELECT
[NUMBER] indicator of the SELECTED OUTPUT
CHANNEL block will alternately display "AL" and
"Ar."
However since all parameters except for DELAY
parameters are linked for the STEREO A/B channels,
you will probably not often need to switch between L
and R channels.
54
Using the STEREO A channel [SEL] switch to
alternate between L and R channels
ST
s t
MATRIX
CHANNEL
COPY
MIX
SHIFT
CHANNEL SELECT
SELECTED OUTPUT CHANNEL
ON ON
TO MTRX MONO
SEL SEL
INS INS
10 10
5 5
0 0
5 5
10 10
ST
s t
MATRIX
CHANNEL
COPY
MIX
SHIFT
CHANNEL SELECT
SELECTED OUTPUT CHANNEL
ON ON
TO MTRX MONO
SEL SEL
INS INS
10 10
5 5
0 0
5 5
10 10
A L
DEC INC
A R
DEC INC