SAFETY INSTRUCTIONS CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK). NO USER-SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL. • Explanation of Graphical Symbols The lightning flash with arrowhead symbol, within an equilateral triangle, is intended to alert you to the presence of uninsulated “dangerous voltage”...
Page 3
We Want You Listening For A Lifetime YAMAHA and the Electronic Industries Association’s Consumer Electronics Group want you to get the most out of your equipment by playing it at a safe level. One that lets the sound come through loud and clear without annoying blaring or distortion –...
INTRODUCTION Thank you for purchasing this YAMAHA product. We hope it will give you many years of trouble-free enjoyment. For the best performance, read this manual carefully. It will guide you in operating your YAMAHA product. FEATURES • Playback of CD-R, CD-RW, and Prerecorded CD Disc Formats •...
DVD player. Regarding erasure or loss of data Yamaha and suppliers accept no liability for the loss of data or any problems caused as a result. As a precaution, it is recommended that the discs are tested after they have been written to.
After unpacking, check that the following parts are contained. • Remote Control TRACK NO. OPEN/ REC MODE WRITE DIMMER DISPLAY CLOSE EFFECT REPEAT RANDOM CLEAR PROG INDEX FINALIZE ERASE REC MUTE SEARCH SKIP STOP PAUSE PLAY Notes on the transportation pad Before using the unit This unit is shipped with a transportation pad inserted in the disc tray to prevent impact to the internal mechanism...
Clean the battery compartment thoroughly before installing new batteries. The remote control Remote control operation range NATURAL SOUND CD RECORDER CDR-S1000 POWER Notes • There should be no large obstacles between the remote control and the main unit.
) in the illustration below indicate the direction of the audio signal. • Guidelines for making both analog and digital connections to this unit are outlined on this and the following page. • When all connections are complete, plug in this unit to a wall outlet. <CDR-S1000> ANALOG LINE IN...
Page 10
• The LINE IN (REC) and LINE OUT (PLAY) jacks of this unit are numbered 4 and 3 respectively. When connecting this unit with a YAMAHA amplifier or receiver whose jacks on the rear panel are numbered as 1, 2, 3, etc., connect the LINE IN (REC) and LINE OUT (PLAY) jacks of this unit to the input jacks numbered 4 and 3 on the rear of the amplifier or receiver.
Turning on the power and loading a disc NATURAL SOUND CD RECORDER CDR-S1000 TRACK NO. EFFECT REC MODE POWER FINALIZE ERASE DISPLAY POWER OPEN/CLOSE TRACK NO. OPEN/ REC MODE WRITE DIMMER DISPLAY CLOSE EFFECT REPEAT RANDOM CLEAR PROG INDEX FINALIZE...
Recording modes This recorder features a number of recording modes allowing you to make recordings from a wide variety of program sources (both analog and digital). • When using this unit to make recordings, subcode information that may be present in the source audio signal such as CD TEXT, index data, etc., will not be recorded.
This is a recording mode suitable for compiling single tracks from different audio sources. A new track marker is automatically placed at the start of the track. REC MODE NATURAL SOUND CD RECORDER CDR-S1000 TRACK NO. EFFECT REC MODE POWER...
This is a recording mode suitable for recording all of the material from a single audio source such as a CD, MD, cassette, or LP. Track markers are automatically placed between the tracks being recorded. REC MODE NATURAL SOUND CD RECORDER CDR-S1000 TRACK NO. EFFECT REC MODE POWER...
CD players. (CD-RW discs can only be played back on a CD-RW compatible player, even if finalization is performed.) Refer to page 20 for more information on finalization. REC MODE NATURAL SOUND CD RECORDER CDR-S1000 TRACK NO. EFFECT REC MODE POWER...
This is a recording mode used when manual control of the recording is required or preferred. (Please note that synchronized recording (single or ALL) is recommended when making a digital recording from CD or MD, etc.) REC MUTE NATURAL SOUND CD RECORDER CDR-S1000 TRACK NO. EFFECT REC MODE POWER FINALIZE...
RECORDING FUNCTIONS Setting the recording levels INPUT NATURAL SOUND CD RECORDER CDR-S1000 TRACK NO. EFFECT REC MODE POWER FINALIZE ERASE DISPLAY Setting the digital recording level The volume level of digital audio sources is often similar, however, level differences may be quite obvious between different digital audio sources and even between one recording and another.
Manual track marking You can manually mark tracks as you like anywhere in your recording. TRACK NO. NATURAL SOUND CD RECORDER CDR-S1000 TRACK NO. EFFECT REC MODE POWER FINALIZE ERASE DISPLAY TRACK NO. OPEN/ REC MODE WRITE DIMMER DISPLAY CLOSE TRACK NO.
• If the power is turned off or interrupted during finalization, the recorded material may be lost and the disc may not be usable. NATURAL SOUND CD RECORDER CDR-S1000 TRACK NO. EFFECT REC MODE...
This operation deletes all data on the disc. It is usually not necessary to perform this function, however, it may be used to recover a disc that was stopped during a finalization or erase operation, etc. NATURAL SOUND CD RECORDER CDR-S1000 TRACK NO. EFFECT REC MODE...
All Track Erase Load a CD-RW disc that has been recorded on. • This function is not possible on a finalized CD-RW disc. Press ERASE until “Erase ALL?” appears on the display. • If you want to cancel the Erase mode, press & (STOP &...
PLAYBACK FUNCTIONS Playing a CD disc This unit is capable of playing CD, CD-R and CD-RW discs. NATURAL SOUND CD RECORDER CDR-S1000 TRACK NO. EFFECT REC MODE POWER FINALIZE ERASE DISPLAY TRACK NO. OPEN/ REC MODE WRITE DIMMER DISPLAY CLOSE...
PLAYBACK FUNCTIONS Program play You can enjoy listening to your favorite tracks in any desired order by programming tracks. NATURAL SOUND CD RECORDER CDR-S1000 TRACK NO. EFFECT REC MODE POWER FINALIZE ERASE DISPLAY $/! ⁄/› DISPLAY TRACK NO. REC MODE...
To check program data 1. During program play, press & (STOP & on the remote). 2. Press PROG on the remote. 3. Each time ⁄/› (SKIP › on the remote) is pressed, the programmed track numbers and their order in the program can be checked one after another. Each time $/! (SKIP $ on the remote) is pressed, the programmed track numbers and their order in the program can be checked in reverse sequential order.
PLAYBACK FUNCTIONS Repeat play You can play a single track or the entire disc repeatedly. TRACK NO. OPEN/ REC MODE WRITE DIMMER DISPLAY CLOSE EFFECT REPEAT RANDOM CLEAR PROG REPEAT INDEX FINALIZE ERASE REC MUTE SEARCH SKIP STOP PAUSE PLAY STOP &...
DIMMER is pressed as follows. Normal illumination Medium dim Maximum dim Listening with Connect the headphones to the PHONES jack and adjust the volume by using LEVEL. NATURAL SOUND CD RECORDER CDR-S1000 TRACK NO. POWER FINALIZE DIMMER OTHER FUNCTIONS headphones...
ADDITIONAL INFORMATION • This compact disc recorder is designed for use with compact discs bearing the only. Never attempt to load any other type of disc into the unit. The unit will also play 8-cm (3-inch) compact discs. • Compact discs are not subjected to wear during play, but damage to the disc surface when the disc is being handled can adversely affect the disc’s play.
Display messages Can’t Copy Digital recording cannot be performed. (See “SCMS copy protection” on page 32.) Disc Full Recording is not possible because there is no blank space remaining on the disc. Track Full Recording is not possible because the maximum number of 99 tracks has already been recorded on the disc.
If it cannot be corrected, or if the fault is not listed in the SYMPTOM column, disconnect the power cord and contact your authorized YAMAHA dealer or service center for help. When talking to the service center, the CDR-S1000 may be needed.
ADDITIONAL INFORMATION SCMS copy protection As a digital audio component, this CD recorder conforms with the Serial Copy Management System (SCMS) standards. The Serial Copy Management System restricts copies made by recording digital signals to first generation copies only. Therefore, a CD disc recorded using a DIGITAL IN jack cannot be used as a source for making another digital recording.
ADDITIONAL INFORMATION CD-Recorder system notes and limitations About track length and number • The CD specifications state that the minimum length of a CD track must be 4 seconds. If a recording is stopped while the track is less than 4 seconds long, the unit will record silence until the 4 second track length requirement has been reached, and then stop recording.
Audio Performance Frequency response ... 5 - 20,000 Hz, ±0.5 dB S/N ratio Playback ... 107 dB Recording ... 90 dB Total harmonic distortion (1 kHz) Playback ... 0.004% Recording ... 0.008% Dynamic range Playback ... 100 dB Recording ... 94 dB Laser Diode Properties Material ...
Need help?
Do you have a question about the CDR-S1000 and is the answer not in the manual?
Questions and answers