Qos Cos; Show Qos Map - Dell PowerConnect 5424 Command Line Interface Manual

Example
The following example configures port g5 to default trust state (CoS).
Console (config)# interface ethernet g5
Console (config-if) qos trust

qos cos

The qos cos Interface Configuration mode command configures the default port CoS value. Use the no
form of this command to return to the default setting.
Syntax
qos cos default-cos
•
• no qos cos
• default-cos — Specifies the default CoS value being assigned to the port. If the port is trusted and
the packet is untagged then the default CoS value becomes the CoS value. (Range: 0 - 7)
Default Configuration
Port CoS is 0.
Command Mode
Interface Configuration (Ethernet, port-channel) mode.
User Guidelines
• You can use the default value to assign a CoS value to all untagged packets entering the port.
Example
The following example configures port g5 default CoS value to 3.
Console (config)# interface ethernet g5
Console (config-if) qos cos 3

show qos map

The show qos map User EXEC mode command displays all the QoS maps.(CHECK WITH MARY)
Syntax
• show qos map [dscp-queue]
• dscp-queue — Displays the DSCP to queue map.
298
QoS Commands