Ipv6 Acls; Access-List Ipv6; Table 26-3 Ipv6 Acl Commands - SMC Networks TigerStack II SMC8926EM Management Manual

IPv6 ACLs

The commands in this section configure ACLs based on IPv6 addresses, next
header type, and flow label. To configure IPv6 ACLs, first create an access list
containing the required permit or deny rules, and then bind the access list to one or
more ports
Command

access-list ipv6

permit, deny
permit, deny
show ipv6 access-list
ipv6 access-group
show ipv6 access-group
access-list ipv6
This command adds an IP access list and enters configuration mode for standard or
extended IPv6 ACLs. Use the no form to remove the specified ACL.
Syntax
[no] access-list ipv6 {standard | extended} acl_name
• standard – Specifies an ACL that filters packets based on the source IP
address.
• extended – Specifies an ACL that filters packets based on the destination
IP address, and other more specific criteria.
• acl_name – Name of the ACL. (Maximum length: 16 characters)
Default Setting
None
Command Mode
Global Configuration
Command Usage
• When you create a new ACL or enter configuration mode for an existing ACL,
use the permit or deny command to add new rules to the bottom of the list.
To create an ACL, you must add at least one rule to the list.
• To remove a rule, use the no permit or no deny command followed by the
exact text of a previously configured rule.
• An ACL can contain up to 32 rules.

Table 26-3 IPv6 ACL Commands

Function
Creates an IPv6 ACL and enters configuration mode for
standard or extended IPv6 ACLs
Filters packets matching a specified source IPv6 address
Filters packets meeting the specified criteria, including
destination IPv6 address, next header type, and flow label
Displays the rules for configured IPv6 ACLs
Adds a port to an IPv6 ACL
Shows port assignments for IPv6 ACLs
26
IPv6 ACLs
Mode Page
GC 26-7
IPv6- 26-8
STD-ACL
IPv6- 26-9
EXT-ACL
PE 26-11
IC 26-11
PE 26-12
26-7