Data Output; Digital Output Selection; Selecting The Interface For A Reduced Data Rate; Reducing Data Output - MICRO-EPSILON optoCONTROL 2700 Operating Instructions Manual

Hide thumbs Also See for optoCONTROL 2700:
Table of Contents

Advertisement

12.12

Data Output

12.12.1

Digital Output Selection

OUTPUT [NONE|([RS422] [ETHERNET] [ANALOG] [ERROROUT])]
Defines the interface for transmitting the measured values or displays the current setting.
NONE: No output
RS422: Output via RS422 (see OUT_RS422)
ETHERNET: Output via Ethernet (see OUT_ETH)
ANALOG: Output via analog output (see ANALOGOUT)
ERROROUT: Error/status information is output via the error output (see ERRORLIMITSIGNAL1 and ERRORLIMIT­
SIGNAL2)
12.12.2

Selecting the Interface for a Reduced Data Rate

OUTREDUCEDEVICE NONE | ([RS422] [ANALOG] [ETHERNET])
Defines the interface via which the output of measured values is to be reduced by only transmitting every nth measured
value.
NONE: No reduction in data output
RS422: Reduced data output via RS422
ANALOG: Reduced data output via ANALOG
ETHERNET: Reduced data output via ETHERNET
12.12.3

Reducing Data Output

OUTREDUCECOUNT [<n>]
Defines or displays the interval for the packets.
Reduces the data output by transmitting only every nth measurement packet.
n: 1 ... 3000000 packet intervals (1 means that all packets will be transmitted)
12.12.4

Error Handling

OUTHOLD [NONE|INFINITE|<n>]
Defines how measured values should be output in the event of an error.
NONE: No hold period, error values are output
INFINITE: Retains the last measured value infinitely
n: 1 ... 1024
Retains the last measured value for a maximum of <n> measurement cycles affected by errors; after that, error values
are output.
12.13

Selecting the Measured Values to be Output

12.13.1

Selecting Ethernet Signals

OUT_ETH [<signal1>] [<signal2>] ... [<signalN>]
Defines the signals that are to be output via Ethernet. The META_OUT_ETH command lists all the signals available for
the output.
optoCONTROL 2700
ASCII Communication
Seite 95

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the optoCONTROL 2700 and is the answer not in the manual?

Subscribe to Our Youtube Channel

Table of Contents