Table of Contents
Advertisement
5.5
Setup Mode
In setup mode, the two-dimensional video signal of the receiver line is displayed.
Advantages of setup mode:
Helps to position the target within the measuring range
●
Horizontal and vertical guide lines with a grid spacing of 0.5 mm
●
Decision-making aid for assessing edge profiles
●
Measuring range in Z direction with ±5 mm
●
You can access setup mode via the menu
EMR
MBE
MMR
MBM
MBA
SMR
X
-5 0 +5
Z
Fig. 5.3: Tilted Fin Profile (Left) and Associated Video Signal (Right), Viewed in Direction of Light Source
5.6
Measurement Chart
The following description is based on the
Light source
Lichtquelle
3B
2B/3A
1B/2A
1A
Fig. 5.4: Punching Profile with Edge Assignment (Left) and Associated Definition of Segments (Right), Viewed in Direction
of Light Source
►
Use the
Measurement chart
►
Under "Chart type", click on Measurement; see figure.
optoCONTROL 2700
Measurement chart
multi-segment
EMR
MBE
MMR
MBM
SMR
MBA
tab to start displaying measured values.
>
Setup
mode.
measuring program.
Operation
Seite 36
Advertisement
Table of Contents
Need help?
Do you have a question about the optoCONTROL 2700 and is the answer not in the manual?