MICRO-EPSILON optoCONTROL 2700 Operating Instructions Manual page 12

Preset
Diameter
Preset
Contour meas­
urement
Preset
Multi-segment
Preset
Gap measure­
ment
Further information on selection and programming can be found in the measuring programs
optoCONTROL 2700
Edge A Kante A
Measurement program Messprogramm
1.60568 mm
Messprogramm: Measurement program:
Durchmesser Diameter
100
Suchrichtung: Search direction:
Standard Standard
Messrichtung: Measurement direction:
0
Standard Standard
Edge A Kante A
Measurement program Messprogramm
-13.46676 mm
Measurement program: Messprogramm:
Durchmesser Diameter
100
Search direction: Suchrichtung:
Standard Standard
Measurement direction: Messrichtung:
0
Standard Standard
1: Kante A 1: Edge A
Measurement program Messprogramm
-15.97021 mm
Messprogramm: Measurement program:
1: Kante A 1: Edge A
Segment Diameter
-0.46457 mm
Suchrichtung: Search direction:
Standard Standard
100
Messrichtung: Measurement direction:
Standard Standard
0
Edge A Kante A
Measurement program Messprogramm
-18.06951 mm
Measurement program: Messprogramm:
Diameter Spalt
100
Search direction: Suchrichtung:
Standard Standard
Measurement direction: Messrichtung:
0
Standard Standard
Edge B Kante B Durchmesser Diameter
11.79993 mm 10.19425 mm
PEAK_A PEAK_B
0 50 75
Bereich [%] Range [%]
Edge B Kante B Durchmesser Diameter
-11.38071 mm 2.08605 mm
PEAK_A PEAK_B
0 25
Bereich [%] Range [%] Range [%]
1: Kante B 1: Edge B 1: Durchmesser 1: Diameter
-10.03696 mm 5.93325 mm
1: Kante B 1: Edge B 1: Durchmesser 1: Diameter
2.36926 mm 2.83383 mm
0 25
Rail (down) Schiene (unten)
Range [%]
Edge B Kante B Durchmesser Diameter
4.00200 mm 22.07151 mm
PEAK_A
0 25
Rail (down) Schiene (unten)
Functional Principle, Technical Data
For measuring the diameter
of cylindrical objects (e.g.
dowel pins, bolts, bar stock,
pipes, hydraulic lines). The
tilt angle of the object in rela­
tion to the measurement
plane is compensated for in
real time by the active tilt cor­
100
Offen (oben) Open (top)
rection.
For measuring component
contours on a stepped turned
part. The lower edge (A), up­
per edge (B), center axis (C),
diameter (D) and the encoder
value are detected.
50
Offen (oben)
Simultaneous measurement
of several objects in the
beam path, e.g. strips or
wires, or targeted detection
of segments selected by the
user. The individual definition
of user and application-spe­
cific segments is possible.
The Multi-segment preset en­
ables individual assignment
50
of the edges to each other.
Bereich [%]
Detailed information is avail­
able in the Advanced settings
chapter.
Measures the gap between
two objects. The width of the
gap and the angular devia­
PEAK_B
tions of the gap edges (AT
and BT) are output. Applica­
tion in rolling systems such
as calender rolls.
50
Bereich [%] Range [%]
Seite 12