Possible Signals For Error Outputs; Assigning The Error Output Signal; Setting The Upper (Overshooting)/Lower (Undershooting) Limit Value For The Switching Outputs; Limits For Overshooting/Undershooting Of Switching Outputs - MICRO-EPSILON optoCONTROL 2700 Operating Instructions Manual

12.14.2

Possible Signals for Error Outputs

META_ERRORLIMITSIGNAL1
META_ERRORLIMITSIGNAL2
META_ERRORLIMITSIGNAL3
Lists all the available signals that can be selected for the corresponding ERRORLIMITSIGNAL1, ERRORLIMITSIGNAL2,
and ERRORLIMITSIGNAL3 commands.
12.14.3

Assigning the Error Output Signal

ERRORLIMITSIGNAL1 [<signal>]
ERRORLIMITSIGNAL2 [<signal>]
ERRORLIMITSIGNAL3 [<signal>]
The command defines or displays the signal for the corresponding switching output. This setting applies to the digital in­
puts and outputs (see OUTPUT ERROROUT).
The META_ERRORLIMITSIGNAL1, META_ERRORLIMITSIGNAL2, and META_ERRORLIMITSIGNAL3 commands list
all the available signals of the corresponding switching outputs that can be used for the output.
See also ERRORLIMITCOMPARETO1 and ERRORLIMITVALUES1, ERRORLIMITCOMPARETO2 and ERRORLIMIT­
VALUES2, ERRORLIMITCOMPARETO3 and ERRORLIMITVALUES3.
12.14.4

Setting the Upper (Overshooting)/Lower (Undershooting) Limit Value for the Switching Outputs

ERRORLIMITCOMPARETO1 [LOWER|UPPER|BOTH]
ERRORLIMITCOMPARETO2 [LOWER|UPPER|BOTH]
ERRORLIMITCOMPARETO3 [LOWER|UPPER|BOTH]
The command defines or returns the limit value for the corresponding error output.
LOWER: Undershooting
●
UPPER: Overshooting
●
BOTH: Undershooting or overshooting
●
12.14.5

Limits for Overshooting/Undershooting of Switching Outputs

ERRORLIMITVALUES1 [<lower limit [mm]> <upper limit [mm]>]
ERRORLIMITVALUES2 [<lower limit [mm]> <upper limit [mm]>]
ERRORLIMITVALUES3 [<lower limit [mm]> <upper limit [mm]>]
This command defines the lower and upper limit values for the relevant switching output or displays the current setting.
The settings are applied to the relevant digital input/output (see ERROROUT1, ERROROUT2, ERROROUT3).
The ERRORLIMITCOMPARETO1, ERRORLIMITCOMPARETO2, and ERRORLIMITCOMPARETO3 commands define
whether the lower limit value, upper limit value, or both limit values should be applied.
<lower limit [mm]> = -2147.0 ... 2147.0
●
<upper limit [mm]> = -2147.0 ... 2147.0
●
optoCONTROL 2700
ASCII Communication
Seite 97