Signals For Ethernet Output; Information About The Output Of Values Via Ethernet; Selecting Rs422 Signals; Signals For Rs422 Output - MICRO-EPSILON optoCONTROL 2700 Operating Instructions Manual

12.13.2

Signals for Ethernet Output

META_OUT_ETH [MEAS|VIDEO|CALC]
Lists all the available signals that can be selected for the OUT_ETH command.
If one of the options MEAS, VIDEO, or CALC is available, the output is filtered and only the selected signal is displayed.
12.13.3

Information About the Output of Values via Ethernet

GETOUTINFO_ETH
Lists all selected output signals for the Ethernet interface.
12.13.4

Selecting RS422 Signals

OUT_RS422 [<signal1>] [<signal2>] ... [<signalN>]
Defines the signals that are to be output via RS422. The META_OUT_RS422 command lists all the signals available for
the output.
12.13.5

Signals for RS422 Output

META_OUT_RS422 [MEAS|VIDEO|CALC]
Lists all the available signals that can be selected for the OUT_RS422 command.
If one of the options MEAS, VIDEO, or CALC is available, the output is filtered and only the selected signal is displayed.
12.13.6

Information About the Output of Values via RS422

GETOUTINFO_RS422
Lists all selected output signals for the RS422 interface.
12.14

Switching output

12.14.1

Limit Value Type for Switching Outputs

ERROROUT1 NONE|ERRORLIMIT|EXPEDGES
ERROROUT2 NONE|ERRORLIMIT|EXPEDGES
ERROROUT3 NONE|ERRORLIMIT|EXPEDGES
The command defines the signal output for the relevant switching output.
NONE: No switching outputs
●
ERRORLIMIT: Error limit defined by the commands
●
ERRORLIMITSIGNAL1, ERRORLIMITVALUES1, and ERRORLIMITCOMPARETO1
ERRORLIMITSIGNAL2, ERRORLIMITVALUES2, and ERRORLIMITCOMPARETO2
ERRORLIMITSIGNAL3, ERRORLIMITVALUES3, and ERRORLIMITCOMPARETO3
EXPEDGES: Error output if CNT_EDGE does not match the value of the EXPEDGES command.
●
optoCONTROL 2700
ASCII Communication
Seite 96