Terminating Resistor; Parameter Management, Load/Save Settings; Basic Settings; Output Of Changed Settings - MICRO-EPSILON optoCONTROL 2700 Operating Instructions Manual

12.8.6

Terminating Resistor

TERMINATION [OFF|ON]
Defines whether a terminating resistor is connected in the synchronization line in order to avoid reflections.
OFF: No terminating resistor
●
ON: Terminating Resistor
12.9

Parameter Management, Load/Save Settings

12.9.1

Basic Settings

BASICSETTINGS READ | STORE
READ: Basic (connection) settings are read from the memory
●
STORE: Basic (connection) settings are stored in the memory
●
12.9.2

Output of Changed Settings

CHANGESETTINGS
MEASSETTINGS is output if any parameters in the measurement settings have changed since the MEASSETTINGS
●
STORE command was last executed.
BASICSETTINGS is output if any parameters in the basic settings have changed since the BASICSETTINGS STORE
●
command was last executed.
12.9.3

Exporting Sensor Settings

EXPORT (MEASSETTINGS <SettingName>) | BASICSETTINGS | MEASSETTINGS_ALL | ALL
Exports the sensor settings.
MEASSETTINGS: Exports the measurement settings with the name <SettingName>
●
BASICSETTINGS: Exports the basic settings only
●
MEASSETTINGS_ALL: Exports all measurement settings
●
ALL: Exports all basic and measurement settings
●
12.9.4

Importing Sensor Settings

IMPORT [FORCE] [APPLY] <ImportData>
Imports settings into the sensor.
FORCE: Allows existing settings to be overwritten
●
APPLY: Applies the imported settings
●
ImportData: Data in JSON format
●
12.9.5

Factory Reset

SETDEFAULT ALL | MEASSETTINGS | BASICSETTINGS
Resets the sensor to its factory settings.
ALL: Deletes all settings and loads the factory settings
●
MEASSETTINGS: Deletes all measurement settings
●
BASICSETTINGS: Deletes all basic settings
●
optoCONTROL 2700
ASCII Communication
Seite 88