Defining Segments; Setting The Measuring Rate; Frame Averaging; Range Of Interest - MICRO-EPSILON optoCONTROL 2700 Operating Instructions Manual

12.10.5

Defining Segments

DEFSEG1 <edge A> <edge B>
DEFSEG2 <edge A> <edge B>
DEFSEG3 <edge A> <edge B>
DEFSEG4 <edge A> <edge B>
DEFSEG5 <edge A> <edge B>
DEFSEG6 <edge A> <edge B>
DEFSEG7 <edge A> <edge B>
DEFSEG8 <edge A> <edge B>
Select the edges for each of the segments 1-8 (edge = 0...252 (252: last edge)).
12.10.6

Setting the Measuring Rate

MEASRATE <frequency>
Defines the measuring rate (frequency) in kHz.
12.10.7

Frame Averaging

FRAME_AVG [ON|OFF]
Switches frame averaging on or off. This command corresponds to frame averaging in the context of data acquisition.
12.10.8

Range of interest

ROI <begin> <end>
Defines the region of interest (0 <= begin < end <= 2047).
12.10.9

Edge filter

EDGEFILTER1 [ON|OFF [<low> <high> [<ignoreval>]]]
EDGEFILTER2 [ON|OFF [<low> <high> [<ignoreval>]]]
Edge filters 1 and 2 prevent signal jumps when measuring over rising edges and steps.
ON|OFF: Activate or deactivate the edge filter
●
Low: Limit value at which the filter is switched off. Value range: -2147.0 ... 2147.0 (unit mm)
●
High: Limit value at which the following measured values are replaced by the last measured value before the limit value
●
is exceeded Value range: -2147.0 ... 2147.0 (unit mm)
ignoreVal: Maximum number of measured values for which the edge filter is applied.
●
12.10.10

Outputting a Signal with the Edge Filter

EDGEFILTER1SIGNAL [<signal>]
EDGEFILTER2SIGNAL [<signal>]
Sets or displays the selected signal for edge filter calculation 1 or 2. The META_EDGEFILTER1SIGNAL and
META_EDGEFILTER2SIGNAL commands list all the available signals that can be used for the output.
optoCONTROL 2700
ASCII Communication
Seite 91