Method For Stopping Engine - Komatsu D61EXi-24 Operation & Maintenance Manual

OPERATION
2.
Place the blade control lever to tilt LEFT position (E) to
move the cylinder to the stroke end, and then keep as it is
for 2 seconds or more.
3.
Check the message on the control box screen.
When "Tilt cylinder" changes to "Angle cylinder" or when
the message of "Cylinder Sensor Reset Request!" goes
out, resetting of the stroke end of tilt cylinder is completed.
REMARK
• If the resetting of the stroke end of tilt cylinder is not
completed, tilt RIGHT the blade once, and repeat step
2 again.
Move the cylinder to the stroke end at certain speed.
• If the resetting of the stroke end of tilt cylinder is not
completed after several trials of step 2, place the
blade control lever to tilt RIGHT position (F) to move
the cylinder to the stroke end of tilt RIGHT side, and
then keep as it is for 2 seconds or more.
RESET ANGLE CYLINDER STROKE END
(When message of "Cylinder Sensor Reset Request!", "Angle cylinder" is displayed)
1.
Raise the blade and tilt it LEFT.
If the blade is not tilted LEFT, the resetting of the stroke end of angle cylinder cannot be done.
2.
Place angle switch (1) to angle LEFT position (G) to move
the cylinder to the stroke end, and then keep it as it is for 2
seconds or more.
3.
Check the message on the control box screen.
When the message of "Cylinder Sensor Reset Request!"
goes out, resetting of the stroke end of angle cylinder is
completed.
REMARK
• If the resetting of the stroke end of angle cylinder is
not completed, angle RIGHT the blade once, and re-
peat step 2 again.
Move the cylinder to the stroke end at certain speed.
• If the resetting of the stroke end of angle cylinder is
not completed after several trials of step 2, place an-
gle switch (1) to angle RIGHT position (H) to move the
cylinder to the stroke end of angle RIGHT side, and
then keep as it is for 2 seconds or more.
• Depending on the length of the pitch rod, resetting of
the stroke end of angle cylinder is only possible for ei-
ther angle LEFT or angle RIGHT.

METHOD FOR STOPPING ENGINE

NOTICE
The power supply of the control box is not linked with the starting switch of the machine. After finishing
the operation, hold down the power ON/OFF and menu switch of control box separately from the start-
ing switch in order to turn off the control box power .
If the power supply of control box is not turned off, the batteries may be exhausted.
MACHINE OPERATIONS AND CONTROLS
3-19