Table of Contents
Advertisement
EXPLANATION OF COMPONENTS
When the blade automatic control is automatically turned off
The blade automatic control is automatically turned off in the
following conditions even if Auto/Manual switch is not pressed.
•
When the machine is stopped for 30 seconds or more
•
When the blade edge protrudes out of the designed range.
•
When the number of GNSS satellites from which the sys-
tem can receive the signals is decreased
•
When the radio waves from the base station cannot be re-
ceived
•
When the starting switch of the machine is turned to OFF
position
•
When there is an abnormality in the system such as open circuit, etc.
"Auto Control Disengaged!" message pops up on the control
box screen and the notice sound "Beep" can be heard when
the blade automatic control is automatically turned off.
At this time, "AUTO" on the control box screen goes out.
CUT/FILL OFFSETS SWITCH
Press the cut/fill offsets switches to adjust the cut/fill offset quantity setting quickly nearby.
The cut/fill offsets switches are located on the right side of the blade control lever.
(1) Cut/fill offsets switch (Up)
When this switch is pressed, the cut/fill offset increases. (De-
sign surface rises.)
(2) Cut/fill offsets switch (Down)
When this switch is pressed, the cut/fill offset decreases. (De-
sign surface lowers.)
The increase/decrease amount when the cut/fill offsets switches are pressed is the same as the setting of the
"Cut/Fill offsets" on the control box screen.
3-10
OPERATION
Advertisement
Chapters
Table of Contents
