Table of Contents
Advertisement
HANDLE CONTROL BOX
REMARK
•
By setting an alignment file from "Surface" or "Alignment" to an active surface, you can use the alignment
file on the steering display.
•
When you select the Alignment file from "Alignment", 3DMC recognizes it as the Surface files for the Steer
Indication.
•
When the same Surface files are selected both on "Surface" and "Alignment", if you cancel the selection on
"Surface", the selection on "Alignment" will also be canceled.
METHOD FOR SELECTING AN ACTIVE AS-BUILT VIEW
When selecting an active as-built view, perform the following procedure.
(You can select by shortcut on the main window as well.)
1.
Press the power ON/OFF and menu switch to display the
main menu.
2.
On "File" menu, press "Active" and "AsBuilt" in order, and
select.
3.
On the main window, select an as-built control screen to
make active.
•
When "Cut Fill" is selected
Current terrain of the position where the machine
passed is displayed by color according to the cut/fill
amount (distance) from the design surface. You can
check the place where digging or raising ground level
work is required.
•
When "Pass Counts" is selected
The position where the machine passed is displayed by color according to the number of times the ma-
chine has passed. You can check the places and numbers of tamping.
EXIT 3DMC
METHOD FOR EXITING 3DMC
1.
Press the power ON/OFF and menu switch to display the
main menu.
2.
On "File" menu, press "Exit 3DMC" and select.
3DMC is finished.
FILE MENU
4-37
Advertisement
Chapters
Table of Contents
