Table of Contents
Advertisement
MACHINE OPERATIONS AND CONTROLS
6.
Turn on the power supply of the control box.
It does not matter if power supply of the base station and
starting switch of the machine are turned off.
7.
Press the power ON/OFF and menu switch to display the
main menu.
8.
Press "Blade calibration" and "Pitch Rod Calibration" in or-
der on the "Control" menu.
9.
Press "Pitch Rod Length:" input portion, and input the
measured length on the "Blade Pitch Rod Calibration"
screen.
10. Press "Ok".
METHOD FOR INPUTTING WEAR AMOUNT OF BLADE EDGE AND TRACK
SHOE
As the cutting edge of blade, track roller or track link wears, finishing accuracy of the blade automatic control
deteriorates and the current ground display has an error. Measure the wear amount and input it to correct this
error.
When these parts wear or they are replaced with new ones, wear amount should be input. Measure the wear
amount and input it.
1.
Stop the machine on a level place.
2.
Lower the blade to the ground.
3.
Operate the work equipment lock lever (1) and parking
brake lever (2) by holding the operating portions on the
top, place the levers in LOCK position (L)
4.
Stop the engine.
3-24
OPERATION
Advertisement
Chapters
Table of Contents
