Table of Contents
Advertisement
MACHINE OPERATIONS AND CONTROLS
If the depth from the current surface (S) to design surface (T) is shallower than the digging depth (a) set in the
blade load mode, the blade moves along the design surface (T).
(R) Shape to be dug
APPLICABLE OPERATIONS BY BLADE CONTROL LEVER WITH CUTTING AND
CARRY MODE
In cutting and carry mode, you can change the digging depth temporarily by operating the blade control lever
while the blade automatic control is in operation. Also, you can adjust the amount of soil to be dug according to
the following procedure.
1.
Operate the blade control lever to RAISE direction (or LOWER direction) while the blade automatic control
is in operation.
The digging depth of the blade is arbitrarily set.
2.
Return the blade control lever to NEUTRAL position.
Keep digging while maintaining the digging depth of this time.
3.
Set the joystick (steering, directional and gear shift lever) to NEUTRAL position (N) or REVERSE position
(R).
Return to the digging depth set in the blade load mode.
(When operating the blade control lever to RAISE direction)
(S) Current surface
3-40
(T) Design surface
OPERATION
Advertisement
Chapters
Table of Contents
