Table of Contents
Advertisement
OPERATION
(R) Shape to be dug
(When operating the blade control lever to LOWER direction)
(S) Current surface
(T) Design surface
In cutting and carry mode, you can spread the dug soils by operating the blade control lever to RAISE direction
while the blade automatic control is in operation and raising the blade higher than the current surface (S).
(R) Shape to be dug
APPLICABLE OPERATIONS BY TILTING BLADE CONTROL LEVER WITH CUT-
TING AND CARRY MODE
The blade normally moves parallel to the design surface (T) while the blade automatic control is in operation. In
cutting and carry mode, you can temporarily set an arbitrary blade angle to the horizontal by performing the tilt-
ing operation of the blade control lever.
1.
Operate the blade control lever to the tilting direction while the blade automatic control is in operation.
The blade angle is arbitrarily set.
2.
Return the blade control lever to NEUTRAL position.
Keep digging while maintaining the blade angle of this time.
3.
Set the joystick (steering, directional and gear shift lever) to NEUTRAL position (N) or REVERSE position
(R).
MACHINE OPERATIONS AND CONTROLS
(R) Shape to be dug
3-41
Advertisement
Chapters
Table of Contents
