Table of Contents
Advertisement
MACHINE OPERATIONS AND CONTROLS
1.
Press Auto/Manual switch once to turn off the blade auto-
matic control.
2.
Check that "AUTO" on the control box screen goes out.
3.
Set the blade control lever to LOWER position (a) and low-
er the blade to the ground.
4.
Hold down the power ON/OFF and menu switch to turn off
the control box power.
REMARK
It takes approximately 2 minutes until the software is fin-
ished and Windows® operating system shuts down after
the power ON/OFF and menu switch is held down.
During this time, you can turn the starting switch of the ma-
chine to OFF position, proceed to the following step.
5.
Set the fuel control dial to Low idle (MIN) position and run
the engine at low idle for approximately 5 minutes.
The engine is cooled gradually.
3-20
OPERATION
Advertisement
Chapters
Table of Contents
