Table of Contents
Advertisement
OPERATION ON MAIN MENU
•
"Advanced" tab (Advanced GNSS options)
You can choose either to use the GLONASS satellite
or not to use it by this setting. This setting applies to
all GLONASS satellites, not individual GLONASS sat-
ellites.
When both of the machine and the base station use GLONASS and the base station is not manufactured by
Topcon, select an applied base station manufacturer such as Sokkia, Trimble, etc. from "Base manufacturer:"
list.
METHOD FOR ADJUSTING CUT/FILL OFFSETS
When adjusting the cut/fill offsets quantity setting, perform the following procedure.
By using the pop-up menu, you can adjust the cut/fill offset quantity setting as well.
When using the pop-up menu, see "METHOD FOR ADJUSTING CUT/FILL OFFSETS (POP-UP MENU)".
1.
On the main window, press "elevation control key".
"Adjust elevation" screen is displayed.
("Set" is displayed in red.)
2.
Press the input section for "Elevation set point".
3.
Input a value by using the numeric keyboard.
4.
Press "Set" and lock "Elevation set point" (cut/fill offsets
quantity setting).
5.
Press "Ok".
REMARK
•
When inputting "Elevation set point", you can set by using Up and Down arrow keys.
•
By using the matching function, you can quickly offset the Design surface to the height of blade edge.
For the operating method, see "METHOD FOR USING AUTOMATIC BLADE CONTROL", "SET SCRAP-
ING DEPTH FROM CURRENT GROUND SURFACE".
4-96
HANDLE CONTROL BOX
AJD02685
Advertisement
Chapters
Table of Contents
