Table of Contents
Advertisement
MACHINE OPERATIONS AND CONTROLS
The message of "Cylinder Sensor Reset Request!" is dis-
played on the control box screen.
"Lift cylinder", "Tilt cylinder", or "Angle cylinder" is dis-
played in the message. Reset the stroke end of the dis-
played cylinder.
•
When no message is displayed
The resetting of the stroke end of every cylinder has been completed, so the resetting is no more necessa-
ry.
RESET LIFT CYLINDER STROKE END
(When the "Cylinder Sensor Reset Request!" , "Lift cylinder" message is displayed)
1.
Place the blade control lever to RAISE position (A) to oper-
ate it to the stroke end, and then keep it for 2 seconds or
more.
2.
Check the message on the control box screen.
When "Lift cylinder" changes to "Tilt cylinder" or "Angle cyl-
inder" or when the message of "Cylinder Sensor Reset Re-
quest!" goes out, resetting of the stroke end of lift cylinder
is completed.
REMARK
•
If the resetting of the stroke end of lift cylinder is not
completed, lower the blade once, and repeat step 1
again.
Move the cylinder to the stroke end at certain speed.
•
If the resetting of the stroke end of lift cylinder is not
completed after several trials of step 1, place the
blade control lever to LOWER position (C) to move the
cylinder to the stroke end of LOWER side, and then
keep it for 2 seconds or more.
Be sure that the surroundings are safe before per-
forming this operation, for the machine will be raised.
RESET TILT CYLINDER STROKE END
(When the message of "Cylinder Sensor Reset Request!", "Tilt cylinder" is displayed)
1.
Raise the blade so that the tilting operation is possible.
3-18
OPERATION
Advertisement
Chapters
Table of Contents
