Table of Contents
Advertisement
INTRODUCTION
HANDLE CONTROL BOX
Example of lighting of LED indicator
When L.H. LED indicator is set to the Cut Fill display, LED lights up as follows.
(When On-grade)
When blade edge is at the height of design surface, 3 (yellow,
green, yellow) LED lamps at the center of indicator light up.
(When blade is off the design surface)
When the blade edge is off the height of design surface beyond
the set On-grade display width, 3 (orange, yellow, green) LED
lamps light up.
The figure shows the example when blade is off toward the Cut
side (where blade edge is higher than the height of design sur-
face).
For the setting method of On-grade display width, see "SET
FOR CONNECTING TO MACHINE".
(When blade is far off the design surface)
When the blade edge is off the height of design surface beyond
the range which the indicator can display, 2 (red, orange) LED
lamps light up.
The figure shows the example when blade is far off toward the
Fill side (where blade edge is lower than the height of design
surface).
REMARK
The function to display the Cut Fill amount or the distance from the steering polyline is similar to the function to
display the grade indicator at the right and left of the screen and the light bar at the lower part of the screen.
Cut Fill amount can be displayed on both LED indicator and grade indicator. You can make the grade indicator
not to be displayed to widen the main window. For the displaying method of grade indicator and light bar, see
"VIEW MENU".
4-8
Advertisement
Chapters
Table of Contents
