Komatsu D61EXi-24 Operation & Maintenance Manual page 156

TOOLS MENU
METHOD FOR SETTING CONSTRUCTION INFORMATION
Once the construction information (Operator, Activity, Delay, Material) are set, the current construction informa-
tion can be checked at the office.
To enable the setting of construction information, the control box must be connected to the Sitelink3D.
In addition, the setting of construction information must be completed as well at the WebPortal of Sitelink3D.
1.
Connect to the Sitelink3D.
2.
Press the power ON/OFF and menu switch to display the
main menu.
3.
On "Tools" menu, press "Sitelink3D" and select.
4.
Press "Operator", "Activity", "Delay", or "Material" and se-
lect.
A list for selection is displayed. Press the desired item to
select it.
REMARK
The construction information set at the WebPortal of Sitelink3D
is displayed in the list for selection.
For the item with no setting of construction information, only
"<none>" is displayed.
METHOD FOR OUTPUTTING DATA
You can select the necessary information from the active Project File and export the Design Surface File to the
devices (control box, 3D-Office, etc.) connected to the same site of Sitelink3D.
To export the data, the control box must be connected to the Sitelink3D.
1.
Connect to the Sitelink3D.
2.
Press the power ON/OFF and menu switch to display the
main menu.
3.
On "Tools" menu, press "Sitelink3D" and "Export data..." in
order.
4-62
HANDLE CONTROL BOX