Komatsu D61EXi-24 Operation & Maintenance Manual page 93

OPERATION
ACTIONS WHEN POP-UP MESSAGE IS DISPLAYED ON CONTROL BOX
Control box screen display
Pop-up message (screen center)
Auto Control Disengaged!
Cylinder Sensor Reset Request! Please move
the Lift cylinder to stroke end and keep it
there for 2 seconds.
Cylinder Sensor Reset Request! Please move
the Tilt cylinder to stroke end and keep it
there for 2 seconds.
Cylinder Sensor Reset Request! Please move
the Angle cylinder to stroke end and keep it
there for 2 seconds.
ACTIONS WHEN Sitelink3D MESSAGE IS DISPLAYED ON CONTROL BOX
The following messages are not abnormalities but take a remedy according to the message if necessary.
Control box screen display
No current "activity" selected!
Please select an activity from the
Sitelink3D menu.
Registered name of terminal:
"Content of message"
Automatic control of blade
(Red)
is turned off from on.
Resetting of the stroke end
(Gray) of lift cylinder is not com-
pleted.
Resetting of the stroke end
(Gray) of tilt cylinder is not com-
pleted.
Resetting of the stroke end
(Gray) of angle cylinder is not
completed.
Main causes
"Activity" of "Sitelink3D"
menu has not been set.
A message is received
from the device which is
connected to the same
site of Sitelink3D.
TROUBLES AND ACTIONS
Main causes
Press the Auto/Manual switch.
For details, see "AUTO/
MANUAL SWITCH".
Perform resetting of the stroke
end of cylinder. For details,
see "RESET CYLINDER
STROKE END".
Remedy
Press "Ok" and close the message screen.
On the control box screen, press "Sitelink3D activity"
or select "Activity" of "Sitelink3D" menu.
If the Activity is not displayed on the drop down list,
register it from the office side.
Even if performing the work without setting the Activi-
ty, it does not affect the work.
No remedy is needed since the message display will
be cleared as time elapsed.
Check the contents of the message by pressing "Si-
telink3D messaging" on the control box screen, or on
"View messages..." of "Sitelink3D" menu.
Remedy
3-75