Table of Contents
Advertisement
FILE MENU
•
When "Continue" is selected
You can extend the end of Surface on the right side/ left side selected in the input section for "Maxi-
mum extension :".
Use this when an intersection point exceeding the end of cross section is expected.
13. Press "Finish".
The new surface file is saved.
ACTIVE FILE
METHOD FOR SELECTING AN ACTIVE SURFACE FILE
When selecting an surface file to be used for control in an actual jobsite (TIN data, Plane Surface file, and Align-
ment file), perform the following procedure.
1.
Press the power ON/OFF and menu switch to display the
main menu.
2.
On "File" menu, press "Active" and "Surface" in order, and
select.
3.
On the main window, select an surface file to make active.
REMARK
•
You cannot use the surface for control by simply taking it in. You can use the surface for control when it is
selected as active data.
•
If there is no check mark (not displayed) on "Show" of the Surface files, the names of Surface files are not
listed in "Active", and you cannot select them.
Put a check mark on "Show" of the Surface files to be selected by referring to "METHOD FOR IMPORTING
SURFACE FILES".
•
When displaying both of TIN data and alignment file and using them for control, select TIN data from "Sur-
face", and then select the alignment file from "Alignment".
METHOD FOR SELECTING AN ACTIVE ALIGNMENT FILE
When selecting an alignment file to be used for control in an actual jobsite, perform the following procedure.
1.
Press the power ON/OFF and menu switch to display the
main menu.
2.
On "File" menu, press "Active" and "Alignment" in order,
and select.
3.
On the main window, select an alignment file to be set ac-
tive.
4-36
HANDLE CONTROL BOX
Advertisement
Chapters
Table of Contents
