An Existing Surface; Method For Creating Alignment File Of Subgrade Of Active Alignment - Komatsu D61EXi-24 Operation & Maintenance Manual

FILE MENU
4.
On "Surface Name and Type" screen, press the input sec-
tion for "Name".
5.
Input the name of Surface files to make newly, by using the
alphanumeric keyboard.
6.
Select "Raise/Lower Existing Surface" ("Surface type"),
and press "Next".
7.
On "Raise/Lower Surface" screen, select an existing Sur-
face to which you add cut/fill amount from "Existing sur-
face:".
8.
Press the input section for "Elevation adjustment :" in the
existing Surface.
9.
Input a value by using the numeric keyboard.
• Positive number
Raises the height of design surface from the surface
which you are working on/ referring to.
This is applied to the centerline of Surface which you
are working on/ referring to.
• Negative number
Lowers the height of design surface from the surface
which you are working on/ referring to.
This is applied to the centerline of Surface which you are working on/ referring to.
10. Press "Finish".
The screen returns to "Project Surfaces" screen.
METHOD FOR CREATING ALIGNMENT FILE OF SUBGRADE OF ACTIVE ALIGN-
MENT
When creating a new alignment data by adjusting an existing alignment data ("Alignment" selectable from "Ac-
tive"), perform the following procedure.
For selecting method for "Active", see "METHOD FOR SELECTING AN ACTIVE SURFACE FILE".
1.
Press the power ON/OFF and menu switch to display the
main menu.
2.
On "File" menu, press "Surfaces..." and select.
4-34
HANDLE CONTROL BOX
AJD02607