Table of Contents
Advertisement
OPERATION ON MAIN MENU
1.
Hold down any point of the main window.
2.
Press "Enabled (left)" in "Set points".
"Cut/Fill offsets" is displayed at the bottom left of the
screen.
3.
Press "Cut/Fill offsets", change the cut/fill offsets quantity
setting, and adjust the cut/fill amount.
4.
Hold down any point of the main window.
5.
Press "Increment" (** m) in "Set points".
By using the numeric keyboard, you can set the intervals
of increase/decrease when "Cut/Fill offsets" is pressed.
REMARK
If you press "Enabled (right)" in "Set points", "Cross slope ad-
justment" is displayed.
You can adjust the lateral slope angle of Surface freely to a cer-
tain angle by pressing "Cross slope adjustment".
4-100
HANDLE CONTROL BOX
Advertisement
Chapters
Table of Contents
