Chapter 4
b)
For minimum oscillation stabilization / setup times refer to the Electrical Target Specification.
Note
172
1.
When IDLE2 mode is released, set the stabilization time to the following
requirements:
– In case of PLL mode: PLL lockup time requirements
– In case of clock-through mode: flash set up time requirement
For the exact timing values, refer to the Electrical Target Specification.
2.
When STOP mode is released, set the stabilization time to the following
requirements:
– In case of PLL mode: PLL lockup time requirement
– In case of clock-through mode:flash set up time requirement
For the exact timing values, refer to the Electrical Target Specification.
3.
If the required oscillation stabilization time of the MainOSC exceeds the
above times, set the value to the required oscillation stabilization time of
the MainOSC.
User's Manual U18743EE1V2UM00
Clock Generator