Overview; Package Checklist For Hotwire Model 7924-A1 - Paradyne HOTWIRE 7924 User Manual

Installing the Unit

Overview

Package Checklist for HotWire Model 7924-A1

7924-A2-GB20-20
This chapter describes the procedure for installing a single standalone
termination unit using a 120 Vac or 230 Vac power supply (Model 7924-A1-20x or
7924-A1-30x).
If you have multiple standalone units at the same location, you may want to
consider installing the units in a HotWire Model 7900 10-Slot Standalone Shelf.
The Standalone Shelf is a convenient method for housing up to ten standalone
termination units and uses only a single power source.
HotWire Model 7924-A1-50x units (which use –48 Vdc direct power) should
always be installed in a HotWire 7900 10-Slot Standalone Shelf. Installation
instructions for these models are not provided in this User's Guide.
To obtain information on the Standalone Shelf, refer to
Documents
on page vi at the beginning of this User's Guide.
Verify that your package contains the following:
A HotWire Model 7924-A1 unit
VT100 Terminal Cable
A 14 twisted-pair network cable
Power cord with power transformer (optional)
Warranty card
August 1997
2
Product-Related
2-1