Table of Contents
Advertisement
Master
2
V Elevator
Aileron
Throttle
Rudder
Gear
Flap
AUX2
AUX3
Program Mix 1
Program Mix 1
Master
Slave
Pos 0
Up
Down
Pas 1
Up
Down
Offset
Throttle Stick
lea==
Elevator
0%
0%
0%
0%
0%
Inhibit
(1.1) Master channel setting
Warning
All Servos Hold?
Ok
Cancel
cleention
DEVO Fl 2E
Welcome to use the DEVO F12E transmitter
(5) Throttle Stick setting
The switch between Pos 1 and Pos 0 can be freely realized through throttle stick after the below amount
has been set up. The below set amount is the position of throttle stick as well as the switch point.
Throttle Stick setting: Press UP or DN to select Throttle Stick seting,
Press R or L to increase or decrease, respectively. The adjustable range
is from 0.0% to 100.0%. Choose Inhibit and the throttle stick will not be
set as a switch.
Pitch Curve
1
Channel
AUX2
Position
Pos 0
Exponential
Off
Point
Point - 1
Stutus
Active
Output
-67%
Throttle Stick
-100%
-100%
(6) Switch Selection
When the item Throttle Stick is set in Inhibit, it is possible to switch between Pos 0 and Pos 1 by Switch.
Press UP or DN to select "Switch". Press ENT to enter Switch interface, press UP or DN to choose desired
item. Press ENT to confirm, the
desired item whose left side will be
changed into "1" from "0". If two or
more items are selected, the item
And should be selected, whose left
side should be changed into "1" from
"0". Press EXT after finished it.
3.17 Program mix
Pitch Curve
g
Switch
g
Position
Exponential
Point
Stutus
Output
Throttle Stick
Switch
Pos 0
Off
Point - 1
Active
-67%
Inhibit
-100%
-100%
0 And
© Flight Mode 0
FMOD 1
oO
FMOD 2
© Flight Mode 3
© Flight Mode
4
© Flap Normal
© Flap Midpoint
There are 8 series of program mix, mix channels and values are adjustable.
Setting Method:
Program Mix
Press ENT enter to Main Menu. Press UP or DN select function, press
ENT to enter function menu, then press UP or DN select "Program Mix".
And press ENT to program Mix setting and current status (default setting
is "Inhibit") interface. Press R or L to choose Inhibit, Normal or Curve.
Take "program mix 1" for example, there are "Normal" and "Curve" setting
(1) The "Normal" setting of "program mix"
Press UP or DN select the "Normal"setting, Press ENT button then pop up "All Servos Hold?" Press R or L
to choose OK or Cancel. If "OK"
selected, all the servos will be locked
in the current status, if "Cancel"
selected, all servos are unlocked.
Press ENT enter to Program Mix 1
setting interface.
Press UP or DN to move the navigatioal mark to select Master option
and press ENT to Master interface. Press UP or DN to select the desired
channel and press ENT to make a "4". Press EXT to be back to Program
Mix 1 interface.
Program Mix 1
V Inhibit
Normal
Curve
Program Mix 2
V Inhibit
Normal
Curve
DEVO Fl 2E —77
Advertisement
Table of Contents
